Hyper3D

The Hyper3D includes the Hyper3D Controller, Hyper3D Emitter and the Hyper3D Glasses which can automatically synchronize the left and right views with the Hyper3D Emitter. It would be more flexible for you to set up a stereo 3D projection system with just one DLP projector for a larger space. According to your requirement, you may purchase as many Hyper3D Emitters (for Daisy-Chain) and Hyper3D Glasses as you need.

Hyper3D Emitter : Detailed Specification       (108KB)

  1. Supports super wide range, long distance of emitting power without any blind corners.
  2. Supports as large space as needed by cascading more Hyper3D Emitters.
  3. Can be synchronized with nVidia 3D driver in left/right eyes.
  4. Easy and flexible Installation to fit any sites.
  5. Powered by AC/DC Adapter.

Hyper3D Emitting Range:



http://www.iart3d.com

Hyper3D Controller: Detailed Specification       (150KB)

  1. It is located at the PC system for remote control of the Hyper3D Emitter and preview of 3D video on the PC console.
  2. Supports Interlacing, Page-Flipping and Sync-Doubling 3D display modes.
  3. Supports both hardware button and software key to switch 3D display modes.
  4. Supports the display resolution of up to 2048x1536 with Sync-Doubling mode.
  5. By using coaxial cable, it can drive the Hyper3D Emitters as many as required.
  6. Powered by USB Power and AC/DC Power Adapter.

Hyper3D Glasses: Detailed Specification       (148KB)

  1. Can be synchronized with Hyper3D Emitter in left/right eyes.
  2. Powered by a 23A/12V Alkaline battery.
  3. Can be continuously used for around 35 hours.
  4. Automatically power shut-down after 30 seconds of no infrared signal detected.
  5. Large glasses to fit any face even with eyeglasses on.